Concox GPS Vehicle tracker Manuel d'utilisateur télécharger pdf (Page 11)

- Under the dash board below the front windshield;

- In the parcel shelf in the rear;

- In the front bumper (non-material face), make sure the device does not get wet;

- Under the wiper version (non-metal), make sure the device does not get wet;

- Non Covert Installation - fix the device on the dash board below windshield.

Device Wiring

1 The standard voltage is 9V-36V, the red wire is the positive, and the black wire is

the negative.

2. Connect the black wire to ground.

5. Quick Operation Instructions

， To properly use the device, common parameters should be set before initial

use. This can be done by using the parameter editor or by sending SMS

commands to the device. (“,"should be English comma and no space

before and after the comma)

5.1 Set APN

Change APN parameter by sending SMS command to the device as follows:

APN,666666,APN name# or APN,666666,APN name,user name,password#

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 28 29

Pas de commentaire

Concox GPS Vehicle tracker Manuel d'utilisateur Page 11